Thermon ZP-PTD100-XP Terminator Manual de usuario descargar pdf (Pagina 2)

Kit Contents 1

Due to the risk of electrical shock, arcing and re caused by

product damage or improper usage, installation or maintenance,

a ground-fault protection device is required.

Installation must comply with Thermon requirements and be

installed in accordance with the regulations as per the norm EN

IEC 60079-14 for hazardous areas (where applicable), or any

other applicable national and local codes.

Component approvals and performance ratings are based on the

use of Thermon specied parts only.

De-energize all power sources before opening enclosure.

Keep temperature sensor and kit components dry before and

during installation.

Minimum bending radius of temperature sensor is 30 mm.

Measuring tip (15 mm in length) should not be bent.

Warnings

4 5

6 7

8 9

2 1 Junction Box Lid

Item Qty Description

Support Cap w/ O-ring

Threaded Grommet Compressor

Grommet

Support Base w/ O-ring

1 1 Expediter Assembly

3 1 Junction Box Base w/ O-ring

4 1 Terminal Blocks w/ DIN Rail

(Refer to terminal specications for maximum allowable wire size)

5 1 Junction Box Lid Cord

6 1 Nut

7 1 Banding Guide

8 1 Power Gland

9 2 Blind Plugs

10 1 to 2 PTD-100 Temperature Sensor

11 1 Sealing Washer

12 2 Banding

0539 II 2G Ex d IIC DEMKO 08 ATEX 0729347U

Temperature Sensor . . .

IP66 48°C ≤ Ta ≤ + 100°C

Certications/Approvals

Tools Required

Terminator-LN-Tool

(order separately)

3 mm

8 mm

19 mm

22 mm

23 mm

29 mm

33 mm

1725 II 2 G&D Ex e II T4-T6 DEMKO 01ATEX0021995

Enclosure . . .

IP66 -60°C ≤ Ta ≤ + 55°C

1 2 3 4 5 6 7 8

Comentarios a estos manuales

Sin comentarios

Thermon ZP-PTD100-XP Terminator Manual de usuario Pagina 2

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware Thermon ZP-PTD100-XP Terminator