Thermon PCA-COM Manual de usuario

For Power Connection, In-Line Splice Connection, T-Splice Connection, or End Termination Applications PCA-COMPower Connection and End Termination KitI

Kit Contents . . .Tools Required . . .Certifications/Approvals . . . 12345Item Quantity Description1 1Expediter Assembly Locknut Gasket 1” NPT

21.2. Slide expediter toward pipe and secure cap to base with the captive screws.1.3. Mount expediter to pipe using two (2) circumferential ba

31.9. Cutandremoveprimaryinsulationjacket. 1.10. Skive outside of black matrix.1.11. Cut V-Notch in matrix and pull bus wires from matrix.

4PCA-COM 3.3. Feed cable and ground lead through expediter base as shown. Feed cable and ground lead through grommet (above the crimp). 3.2.

53.10. Apply a liberal amount of RTV sealant to cable.3.11. Slide boot onto the end of the cable.4.1. Slide the metallic braid back from the end

6INSTALLATION PROCEDURES5.1. Mountjunctionbox(Soldseparately) on expediter using gasket and locknut provided.5.2. Install power connection

Form No. 50400-0208THERMON . . . The Heat Tracing Specialists®100ThermonDr.• PO Box 609 • San Marcos, TX 78667-0609Phone: 512-396-5801 • Facs