Thermon RGS-CFK Manual de usuario descargar pdf (Pagina 2)

RGS

TM

-CFK Power Connection and End Termination Kit

Tools Required for Installation

Scissors, crimper/cutter, flat-blade screw-

driver, and utility knife

Kit Contents

User supplied junction box must be rated

Type 4X (water-tight) and approved for use

in ordinary locations.

Step 2: Cut overjacket back a distance of

5" (120 mm).

Step 3: Separate braid strands at

overjacket and pull cable back through

opening in braid.

Step 4: Cut insulating jacket of cable back

3.5" (90 mm). Wind braid into a pigtail.

Step 5: Skive outer matrix material from

conductors with a utility knife.

Step 6: Peel ex-

posed wires back

from center ma-

trix and cut cen-

ter matrix away,

leaving bare conductors. Twist end of bus

wires before inserting into boot to avoid

contact with ground wire.

Step 7: Squeeze

RTV into the sili-

cone rubber

boot and slide

over cable end.

Verify bus wires do not contact ground

wire.

Power Connection

Step 1: Slide the junction box fitting cap,

strain relief disk, grommet, and then gland

fitting body onto the power end of cable.

1 2 3 4

Comentarios a estos manuales

Sin comentarios